Software Upgrade; Firmware Upgrade Through Tftp/Http/Https - Grandstream Networks HT802 User Manual

Software upgrade can be done via either TFTP or HTTP. The corresponding configuration settings are in
the ADVANCED SETTINGS configuration page.

FIRMWARE UPGRADE THROUGH TFTP/HTTP/HTTPS

To upgrade via TFTP or HTTP/HTTPS, the "Firmware Upgrade and Provisioning upgrade via" field needs
to be set to TFTP HTTP or HTTPS, respectively. "Firmware Server Path" needs to be set to a valid URL
of a TFTP or HTTP server, server name can be in either FQDN or IP address format. Here are examples
of some valid URL.
e.g. firmware.mycompany.com:6688/Grandstream/1.0.5.2
e.g. firmware.grandstream.com
NOTES:

Firmware upgrade server in IP address format can be configured via IVR. Please refer to the
CONFIGURATION GUIDE section for instructions. If the server is in FQDN format, it must be set
via the web configuration interface.

Grandstream recommends end-user use the Grandstream HTTP server. Its address can be
found at http://www.grandstream.com/support/firmware
address is firmware.grandstream.com. For large companies, we recommend to maintain their
own TFTP/ HTTP/HTTPS server for upgrade and provisioning procedures.
 Once a "Firmware Server Path" is set, user needs to update the settings and reboot the device. If
the configured firmware server is found and a new code image is available, the HT802 will
attempt to retrieve the new image files by downloading them into the HT802's SRAM. During this
stage, the HT802's LEDs will blink until the checking/downloading process is completed. Upon
verification of checksum, the new code image will then be saved into the Flash. If
TFTP/HTTP/HTTPS fails for any reason (e.g. TFTP/HTTP/HTTPS server is not responding, there
are no code image files available for upgrade, or checksum test fails, etc), the HT802 will stop the
TFTP/HTTP/HTTPS process and simply boot using the existing code image in the flash.

Firmware upgrade may take as long as 15 to 30 minutes over Internet, or just 5 minutes if it is
performed on a LAN. It is recommended to conduct firmware upgrade in a controlled LAN
environment if possible. For users who do not have a local firmware upgrade server,
Grandstream provides a NAT-friendly TFTP server on the public Internet for firmware upgrade.
FIRMWARE VERSION 1.0.0.5

SOFTWARE UPGRADE

HT802 USER MANUAL
. Currently the HTTP firmware server IP
Page 39 of 46