Sanyo PLC-XU105 Owner's Manual page 49

Lamp control
This function allows you to change brightness of the screen.
Auto ........... The brightness according to the input signal
(between High and Eco mode).
High ........... Brighter than the Normal mode.
Normal ....... Normal brightness
Eco ............ Lower brightness reduces the lamp power
consumption and extends the lamp life.
Remote control
This projector provides two different remote control codes;
the factory-set, initial code (Code 1) and the secondary
code (Code 2). This switching function prevents remote
control interference when operating several projectors or
video equipment at the same time.
When operating the projector in "Code 2", both the
projector and the remote control must be switched to "Code
2".
To change the code for the projector;
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control;
Press and hold both the MENU and IMAGE buttons
together for 10 seconds or more. After changing the code,
make sure the remote control operates properly.
Remote control
Setting
Press and hold
MENU and
IMAGE buttons
for 10 seconds or
more.
49