Optional accessories
If using a multi system, refer to the manual supplied with the outdoor unit.
The following connection accessories are optional. If they are not supplied, you should obtain them before installing the air
conditioner.
Insulated
Insulated Assembly
Assembly Pipe,
Pipe, Ø9.52mm (1)
Ø6.35mm (1)
07/09/12
Rubber Legs (4)
Pipe Clamps A (3)
Tools required for installation
General Tools
Tools for test operations
Fixing the installation plate
You can select the direction of the drain hose depending on where you want to install the indoor unit. Therefore before fixing
the installation plate to a wall or a window frame, you must determine the position of the 65mm hole through which the cable,
pipe and hose pass to connect the indoor unit to the outdoor unit.
1. Determine the position of the pipe and drain hose hole as seen in the picture and drill the hole with an inner diameter
of 65mm so that it slants slightly downwards.
Pipe hole
(Ø65mm)
B
Maldive EUR_AQV09P@_IBIM_32436A_E.indd 27
Insulated Assembly Pipe,
Insulated Assembly Pipe,
Ø12.70mm (1)
Ø15.88mm (1)
18
24
Pipe Clamps B (3)
Cement Nails (6)
Direction of pipe
A
D
D
C
Model
A
07/09/12
27 120 68
18/24
34 140 68
C
PE T3 Foam Tube
Vinyl Tapes (2)
Insulation (1)
M4 x 25 Tapped
Drain Hose,
Screws (6)
length 2m (1)
B
B
C
D
27
hole after choosing the
34
direction of the pipe.
Drain Plug (1)
Putty 100g (1)
27
2010-11-11 15:02:18