Table of Contents
Advertisement
Optional accessories
If using a multi system, refer to the manual supplied with the outdoor unit.
The following connection accessories are optional. If they are not supplied, you should obtain them before installing the air
conditioner.
Insulated
Insulated Assembly
Assembly Pipe,
Pipe, Ø9.52mm (1)
Ø6.35mm (1)
09/12
Pipe Clamps A (3)
Pipe Clamps B (3)
• If these accessories are supplied, they will be in the accessory box.
Tools required for installation
General Tools
• Vacuum Pump(Backward fl owing prevention)
• Torque Wrench
• Screw Driver
Tools for test operations
• Thermometer
Fixing the installation plate
You can select the direction of the drain hose depending on where you want to install the indoor unit. Therefore before fi xing
the installation plate to a wall or a window frame, you must determine the position of the 65mm hole through which the cable,
pipe and hose pass to connect the indoor unit to the outdoor unit.
When facing the wall, the pipe and cable can be connected from the:
• Right (A)
• Left (B)
• Underside_right (C)
• Rear_right or left (D)
1. Push the mark up at the bottom of the indoor unit to detach the plate.
AQV09K&Y@@_Jungfrau_IBIM_E_32448A.indd 29
Insulated Assembly Pipe,
PE T3 Foam Tube
Ø12.70mm (1)
Insulation (1)
18
Cement Nails (6)
M4 x 25 Tapped
• Pipe Cutter
• Reamer
• Spanner
• Drill
• Resistance Meter • Electroscope
Direction of pipe
A
D
D
C
Vinyl Tapes (2)
Drain Hose,
Screws (6)
length 2m (1)
• Manifold Gauge
• Stud Finder
• Pipe Bender
• Spirit Level
• L Wrench
• Measuring Tape
B
Drain Plug (1)
Rubber Legs (4)
Putty 100g (1)
29
2011-3-19 15:45:34
Advertisement
Table of Contents
