Garmin 500 Series Installation Manual page 35

4.4.2.4 Superflags
Pin Name
MAIN LATERAL SUPERFLAG
MAIN VERTICAL SUPERFLAG
The output supplies not less than 500 mA on a 28 volt system and 250 mA on a 14 volt system with the
output voltage not less than (AIRCRAFT POWER – 1.5 V
output voltage with respect to ground is less than 0.25 V
4.4.2.5 OBS
Pin Name
MAIN OBS ROTOR C
MAIN OBS ROTOR H (GROUND)
MAIN OBS STATOR D
MAIN OBS STATOR E (2.5V COMMON OBS)
MAIN OBS STATOR F
MAIN OBS STATOR G (2.5V COMMON OBS)
MAIN OBS ROTOR C and H are a buffered output that is intended to drive the OBS rotors. MAIN OBS
STATOR D and MAIN OBS STATOR F are each phase and amplitude shifted version of the MAIN
ROTOR C output. Each pair is intended to read one of the two windings of the indicator's OBS stator.
4.4.3 Main Indicator Configuration
Refer to section 5.2.8 for the main CDI/OBS configuration.
4.4.4 Main Indicator Calibration and Checkout
Refer to section 5.2.8 for the main CDI/OBS checkout.
4.4.5 Main Indicator Interconnect
Refer to Figure 4-7 on page 4-35 for the generic main indicator interconnect. Refer to Figure 4-8 on page
4-37 for the interconnect between a GNS 530 and a Bendix/King KI 209A. Refer to Figure 4-9 on page 4-
39 for the interconnect between a GPS 500 or GNC 520 and a Bendix/King KI 208A.
Page 4-8
Page Rev. B
Connector Pin
P5001 17
P5001 18
) when the flag is to be OUT OF VIEW. The
DC
when the flag is to be IN VIEW.
DC
Connector Pin
P5001 31
P5001 32
P5001 33
P5001 34
P5001 35
P5001 36
500 SERIES INSTALLATION MANUAL
I/O
Out
Out
I/O
Out
Out
In
Out
In
Out
P/N 190-00181-02