Table of Contents
Advertisement
B. Vent Components Diagrams (continued)
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm)
the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a
DVP-HSM-B will be required.
15-1/8 in.
(384 mm)
12 in.
(305 mm)
SLP-DCF-BK
Ceiling Firestop
Black
Figure 16.8 SLP Series Vent Components
68
8 in.
(203 mm)
SLP-TRAP
Horizontal Termination Cap
SLP-SNKD
Snorkel
Termination Cap
DVP-2SL
Wall Thimble-Black
Heat & Glo • BE-41C / LP, BE-41IPIC / LP • 2105-900 Rev. P • 6/09
Heat
Shield
Max
Effective
Length
SLP-CCS-BK
Cathedral Ceiling
Support Box-Black
26 in.
660 mm
DVP-HSM-B
Extended Heat Shield
SLP-WT-BK
Minimum
Term Cap
Effective Length
Effective Length
3-1/8 in.
Trap1
79 mm
5-1/4 in.
Trap2
133 mm
SLP-TVHW
Vertical
Termination Cap
PVK-80
(For use with IPI and DSI appliances only.)
Maximum
4-3/4 in.
121 mm
9-1/4 in.
235 mm
Advertisement
Table of Contents
