Heat & Glo BE-41C Owner's Manual page 55

5. The grate is located in the lower cavity.
Remove the screw holding the grate
in place and discard the screw.
6. Position the grate into the cutout in the
refractory. Hook the grate into position
using the tabs on the bottom of the
grate. Make sure the grate is pulled
forward on the refractory (see Figure
4).
7. Cut shrink wrap and remove from
around the log assembly.
NOTICE: Remove all packaging from logs.
8. Install embers. See Ember Placement
section of the Owner's Manual for
details.
WARNING! Risk of Explosion! Follow em-
ber placement instructions in manual. DO
NOT place embers directly over burner ports.
Replace ember material annually. Improperly
placed embers interfere with proper burner
operation.
9. Carefully position the log set in the
fi replace. Pull the log set forward until
the log set contacts the log placement
tabs. Center the log set in the fi rebox
side to side as shown in Figure 5.
Grate has been removed in Figure 5
photo only for purpose of illustration.
Figure 4
Figure 5
Heat & Glo • BE-41C / LP, BE-41IPIC / LP • 2105-900 Rev. P • 6/09
Log Placement Tabs
55