Separating The Cutting Unit From The Traction; Unit - Toro 30357 Operator's Manual

1
Removing the Grass Deflector
No Parts Required
Procedure
1. Position the machine on a level surface, lower the
cutting unit to the floor, move the lift lever to the Float
position, shut the engine off, remove the key from the
ignition switch and engage the parking brake.
2. Remove the locknut, bolt, spring and spacer holding
the deflector to the pivot brackets
the grass deflector.
Note: Save all the grass deflector components for use
when changing to the side discharging mode.
1. Bolt
2. Spacer
3. Locknut
2
Separating the Cutting Unit
from the Traction Unit
No Parts Required
Procedure
1. Remove the capscrew and washer mounted to the top
of each height of cut rod
2. Remove the hairpin and clevis pin securing the height
of cut collar to the height of cut rod on the rear of the
cutting unit (Figure
(Figure 2). Remove
Figure 2
4. Spring
5. Grass Deflector
(Figure 3).
3). Remove the height of cut collar.
3. Remove the hair pin cotters and clevis pins securing
the lift arms to the castor arm brackets
4. Roll the cutting unit away from the traction unit,
separating the male and female sections of the PTO
shaft.
DANGER
If the engine is started and the PTO shaft is
allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO
lever when the PTO shaft is not connected to
the gear box on the cutting unit.
1. Lift arm
2. Castor arm bracket
3. Height of cut rod
4. Lift arm pads
5. Thrust washers
6. Clevis pin
7
(Figure
Figure 3
7. Hair pin cotter
8. Height of cut collar
9. Clevis pin
10. Hair pin cotter
11. Capscrew
3).