Mounting The Blower - Toro 30357 Operator's Manual

3

Mounting the Blower

Parts needed for this procedure:
1 Discharge shelf
2 Carriage bolt, 3/8 x 1 in
2 Flange nut, 3/8 in
1
Front baffle
3 Capscrew, 3/8 x 1 in
1 Carriage bolt, 3/8 x 1 in
3 Washer
4 Flange nut, 3/8 in
1 Rear baffle
2 Capscrew, 3/8 x 1 in
2 Flange nut, 3/8 in
1 Drive pulley
1 Pulley nut
2 Spring clip
2 Pan head screw, #8 x 1/2 in
2 Nut, #8
1 Tie-down bracket
3
Carriage bolt, 5/16 x 1 in
3 Locknut, 5/16 in
1 Belt cover mounting bracket
2 Capscrew, 5/16 x 1 in
2 Locknut, 5/16 in
1 Blower assembly
1 V-belt
1 Belt cover
Procedure
1. Raise and block up the right side of cutting unit so the
castor wheel is just off of the floor.
2. Remove the bolts and nuts securing the right castor arm
to the cutting unit (Figure 4). Remove the castor arm.
1. Right Castor arm
3. Remove the two right deck covers and the center deck
cover from the top of the cutting unit
1. Right deck covers
2. Center deck cover
3. Cam lock
4. Remove the cam lock, washer, nut and bolt securing
the adjustable flow baffle to the cutting unit
Remove the baffle and components.
5. Remove the bolts and nuts securing the discharge
baffle to the cutting unit
and components.
Note: Save the baffles and hardware for use when
changing to the side discharging mode.
8
Figure 4
(Figure
Figure 5
4. Adjustable flow baffle
5. Discharge baffle
(Figure
(Figure 5). Remove the baffle
5).
5).