Extreme Networks Summit 300-48 Software User's Manual page 167

Extreme summit 300-48: software user guide
Hide thumbs Also See for Summit 300-48:
Table of Contents

Advertisement

supports four hardware queues. The transmitting hardware queue determines the bandwidth
management and priority characteristics used when transmitting packets.
To control the mapping of 802.1p prioritization values to hardware queues, 802.1p prioritization values
can be mapped to a QoS profile. The default mapping of each 802.1p priority value to QoS profile is
shown in Table 67.
Table 67: 802.1p Priority Value-to-QoS Profile to Hardware Queue Default Mapping
Priority Value QoS Profile
0
1
2
3
4
5
6
7
802.1p Commands
Table 68 shows the command used to configure 802.1p priority. This is explained in more detail in the
following paragraphs.
Table 68: 802.1p Configuration Commands
Command
config vlan <name> priority <number>
Configuring 802.1p Priority
When a packet is transmitted by the switch, you can configure the 802.1p priority field that is placed in
the 802.1Q tag. You can configure the priority to be a number between 0 and 7, using the following
command:
config vlan <name> priority <number>
Replacing 802.1p Priority Information
By default, 802.1p priority information is not replaced or manipulated, and the information observed on
ingress is preserved when transmitting the packet. This behavior is not affected by the switching or
routing configuration of the switch.
However, the switch is capable of replacing the 802.1p priority information. To replace 802.1p priority
information, you will use an access list to set the 802.1p value. See Chapter 10, "Access Policies", for
more information on using access lists. You will use the
create access list
corresponds to the new 802.1p value.
Summit 300-48 Switch Software User Guide
Hardware Queue
Priority Value
Qp1
1
Qp2
1
Qp3
2
Qp4
2
Qp5
3
Qp6
3
Qp7
4
Qp8
4
command to replace the value. The packet is then placed on the queue that
Description
Configures the 802.1p priority value for 802.1Q
VLAN tags. The value for priority is an
integer between 0 and 7.
set dot1p <dot1p_value>
Traffic Groupings
parameter of the
167

Advertisement

Table of Contents
loading

Table of Contents