Great Dane Chariot GCHKW1948S Owner's/Operator's Manual page 20

Lubricate seat platform hinges (6), throttle
cable (7) and choke cable (8) (figure 15).
7
Figure 15
Changing Engine Oil And Filter
(Figure 16)
NOTE: Refer to engine manual for
recommended oil and filter changed intervals
based on operating conditions.
To change oil and filter:
1. Run engine until warm.
2. Engage the parking brake.
3. Move both steering levers to the neutral
lock position.
4. Install a suitable drain tube on the
engine oil drain valve (1).
5. Place a suitable container under the
drain tube.
1
1. Engine Oil Drain Valve
2. Oil Filter
Figure 16
6. Open the drain valve and allow oil to
drain.
7. Remove oil filter (2) by turning
counterclockwise.
8. Apply a thin coat of fresh engine oil to
the gasket on the new filter.
6
8
2
GB - 20
9. Install filter and turn until gasket makes
contact with mounting surface. Tighten
an additional 1/2 to 3/4 turn.
10. Close drain valve and remove drain
tube.
11. Remove engine oil fill/dipstick from
engine. See figure 16.
1
1. Engine Oil Fill/Dipstick
Figure 17
12. Add engine oil per engine
manufacturer's recommendations.
13. Replace dipstick. Run engine and check
for leaks.
Replacing Fuel Filter
(Figure 18)
To change oil and filter:
1. Shut off engine and allow to cool
completely.
2. Engage the parking brake.
3. Move both steering levers to the neutral
lock position.
4. Place a suitable container under the fuel
filter.
5. Remove clamps retaining fuel filter and
remove filter.
2
1. Fuel Filter
2. Clamps
Figure 18
1