Great Dane Chariot GCHKW1948S Owner's/Operator's Manual page 13

Mounting and Dismounting Machine
Do not step
on mower
deck.
Do not step on the mower deck when
mounting and dismounting the machine.
Mount the machine from the front using the
foot plate platform.
Keep the foot plate platform clean.
Ignition Switch
1
2
3
detailed instructions on how to start engine.
IMPORTANT: Avoid damage. Starter may be
damaged if starter is operated for more than
20 seconds at a time. Wait two minutes
before trying again if engine does not start.
Choke Control Knob
Foot Plate
Platform
Figure 4
Operate the
ignition switch
with the
removable key.
The switch has
three positions:
STOP (1), Run
(2) and Start (3).
See Starting and
Shut Off on
page 15 for
Pull the choke knob out
to start a cold engine.
Push the choke knob in
when the engine gets
warm.
Throttle Lever
Changes the speed of engine.
1
2
Power Take Off (PTO) Switch
1 2
Hour Meter
ignition switch in the run position. Always
ensure that key is OFF when unit is not
operating.
See MAINTENANCE SCHEDULE on
page 17 or refer to Engine Manual for
maintenance intervals.
Steering Levers
Forward and rearward motion of the steering
levers is prevented when the steering levers
are in the neutral lock position.
NOTE: Both levers must be in the neutral
lock position to start the engine.
GB - 13
Fast (1) – Increases engine
speed.
Half Throttle – Place in this
position when starting and
warming unit.
Slow (2) – Decreases engine
speed.
Engages (1) and
disengages (2) mower
blades.
Pull PTO switch out to
engage mower blades.
Push PTO switch in to stop
mower blades.
Indicates the number of
hours that the unit has
run.
NOTE: Hour meter will
continue to run with the