Digicom Tiziano 56 Memory User Manual page 29

Tiziano 56 Memory
If you decide to use the microphone connected to the modem, check, in
the window of voice message recording, that the recording option is
selected on modem.
If you decide to use the microphone connected to the audio card, check,
in the window of voice message recording, that the recording option is
selected on audio card.
3) By using the terminal emulation program, send the AT$M0 command and
then AT%G1 or AT%G2. This allows to select the storage of the welcome
message "Answer and Record" or "Answer Only".
4) Newly activate the fax/voice application and select the welcome message
previously stored. Check the voice message listening is enabled on modem
and not on audio card.
5) Wait until the PWR led turns orange continuous and then activate the
listening of the message with Play. The recording of the welcome message
starts. During the recording the PWR led must turn orange lightening.
6) Once the recording is over, the PWR led will turn green.
7) By using a terminal emulation program send the AT$M0 command and
then the AT%R0 and AT%R1 to activate one of the two welcome messages.
8) In order to check if the recording of the message has been correctly carried
out, send from a terminal emulation the commands AT$M0 and AT%Px of
the activated message and listen to the message.
9) Tiziano 56 Memory is now ready to be used with the Memory function and
the customized message.
NOTE: This procedure allows you to record one welcome message at a time. If you want
to record the second welcome message, you have to repeat the procedure. This
procedure can be activated only when the memory is free from voice messages and
faxes.
The command AT%Rx allows to choose the welcome message to be used.
In any case, when the modem memory is full, the "Answer Only" message is
activated.
Performance when Computer is Off
4.3