Digicom Tiziano 56 Memory User Manual page 17

TIZIANO 56 MEMORY
ATX DIAL TONE DETECTION
X0 No control on dial tone.
X1 Busy and dial tone are ignored.
X2 Dial tone detected.
X3 Busy tone detected.
X4 All messages enabled.
ATZ RESET AND LOAD USER PROFILE
Z0 Reset and load user profile 0.
Z1 Reset and load user profile 1.
AT+MS= MODULATION FORMAT
This extended-format command selects the modulation, optionally enables
or disable automode, and optionally specifies the lowest and highest rates
using one to four subparameters. the command format is:
AT+MS=[mod],[automode],[min_rate],[max_rate]
# [mod]
# [automode]
# [min_rate]
# [max_rate]
Modulation type (see the table below)
MOD
0
1
2
3
9
10
11
12
56
64
69
Automode: see the ATN command
Line speed min/max: These parameters permit to define, within a
modulation standard, the minimum and maximum connection rate.
The AT+MS? command shows the currently modem configuration, the
default value is: 12,1,300,56000
= modulation type
= automode enable or disable
= min. line speed
= max.line speed
MODULATION
V.21
V.22
V.22bis
V.23
V.32
V.32bis
V.34
V.90
K56Flex
Bell 103
Bell 212
3.5
Modem AT Command Set
POSSIBLE RATE bps
300
1200
2400 or 1200
1200
9600 or 4800
from 14400 to 4800
from 33600 to 2400
from 56000 to 28800
from 56000 to 32000
300
1200