Table of Contents
Advertisement
Control panel
!¶
!§
!∞ !¢
MUTING
VOLUME
PICTURE
MEMORY
+
–
AUDIO
RESET
1 POWER keys
ON : Press to turn on the power when the projector is
in the standby mode. The POWER indicator lights
in green when the power is turned on.
OFF : Press to turn off the power.
2 Indicators
POWER: Lights in green when the power is turned
on.
Flashes in green while the cooling fan runs after
turning off the power with the POWER OFF key.
The fan runs for about two minutes after turning
off the power.
The POWER indicator flashes quickly for the first
minute. During this time, you will not be able to
turn the power back on with the POWER ON key.
STANDBYu: Lights in red when the MAIN
POWER switch at the rear of the projector is
turned on.
Once in the standby mode, you can turn on and off
the projector with the POWER ON/OFF keys on
the Remote Commander or the control panel.
Note
When the MAIN POWER switch is turned off,
there will be a slight delay before the STANDBY
indicator goes off.
3 Error code display window
Displays the error codes.
For details on the error codes, see "Error codes" on page
42 (EN).
!£
!™
!¡
!º
9 8
LENS CONTROL
MENU
SHIFT
ZOOM
FOCUS
+
+
–
–
ENTER
7
6
INPUT SELECT
PATTERN
VIDEO
A
B
+
–
SELECT
VIDEO/S VIDEO
Note
When the lamp is warm, it may not light up easily.
In this case, 88 appears in the error code display
window, but this is not malfunction.
If 88 remains lit for more than three minutes after
turning on the power, never open the lamp cover if
the projector is installed on the ceiling.
4 Rear remote control detector
5 LIGHT key
Lights the back lighting for the keys on the control
panel when the projector is turned on. Press again to
turn off the back lighting. If you do not press any key
for 30 seconds, back lighting turns off automatically.
6 INPUT SELECT keys
Select the input signal.
VIDEO: Selects the video signal input from the
VIDEO or S VIDEO connectors and the audio
signal input from the AUDIO IN L/R jacks. To
switch the S VIDEO and VIDEO connectors, use
the SELECT key.
SELECT: Each time you press this key, the input
video signal is switched between the VIDEO and
S VIDEO connectors.
A: Selects the audio and video signals input from the
INPUT A connectors.
B: Selects the signal input from the connectors on the
optional interface board (other than IFB-40) which
is installed in the INPUT B section.
7 PATTERN key
Displays an H pattern on the screen for focus, zoom,
and shift adjustments. Press again to clear the H
pattern.
5
4
3
2
1
POWER
ON
LIGHT
STANDBY u
OFF
g
(Continued)
9
(EN)
Advertisement
Table of Contents
