Table of Contents
Advertisement
3
Switch on equipment connected to the projector. Press the INPUT
SELECT keys on the Remote Commander or the control panel to
select the input source.
VIDEO: Selects the video signal input from the VIDEO or S
VIDEO connectors and the audio signal input from the
AUDIO IN L/R jacks. To switch the VIDEO or S VIDEO
connectors, use the SELECT key.
SELECT: Each time you press this key, the input signal is switched
between VIDEO and S VIDEO.
A:
Selects the audio and video signals input from the INPUT
A connectors.
B:
Selects the signal input from the connectors on the optional
interface board (other than IFB-40) which is installed in the
INPUT B section.
When you input the signal from equipment connected to the optional
signal interface switcher, set the SWITCHER/INDEX/LENS selector
on the Remote Commander to the SWITCHER position and designate
the channel number by pressing the number keys.
4
Set the SWITCHER/INDEX/LENS selector to the LENS position, and
then press the PATTERN key on the Remote Commander or the
control panel to display the H pattern.
H H H H
H H H H
H H H H
H H H H
H H H H
H H H H
H H H H
H H H H
H H H H
H H H H
Press the PATTERN key again to clear the H pattern.
5
Press the FOCUS +/– key on the Remote Commander or the control
panel to adjust the focus.
"FOCUS" appears on the screen during adjustment.
6
Press the ZOOM +/– key on the Remote Commander or the control
panel to adjust the zoom.
"ZOOM" appears on the screen during adjustment.
7
Press the FOCUS +/– key on the Remote Commander or the control
panel again to adjust the focus.
"FOCUS" appears on the screen during adjustment.
(Continued)
19
(EN)
Advertisement
Table of Contents
