Table of Contents
Advertisement
Location and Function of Controls
Front
1
2
3
1 Remote Commander pocket
Houses the supplied Remote Commander. When
inserting the Remote Commander, make sure the
infrared transmitter is facing forwards and push it until
it clicks.
To take out the Remote Commander from the pocket,
push it once and pull it out.
2 Front remote control detector
3 Lens
Remove the lens cap before projection.
4 Front ventilation holes (intake)
Do not place anything within the 50 cm (19
range from these holes or block them.
5 Adjusters
Use the adjusters to keep the projector level if it is
installed on an uneven surface.
6 Bottom ventilation holes (exhaust)
Do not block the holes.
7 Adjuster screw
Adjusts the height of the adjuster.
!£
!™
4
5
3
/
inches)
4
!¡
6
7
8
8 Handle lever
Use the lever for putting away the carrying handle.
9 Carrying handle
Pull out the handle for carrying the projector.
0 Right side ventilation holes (exhaust)
Do not block the holes.
!¡ Speaker
!™ Lamp cover
!£ Left side ventilation holes (intake)
Do not place anything within the 30 cm (11
range from these holes or block them.
Notes
• Do not block the ventilation holes, or internal heat
build-up may occur, causing fire or damage to the
projector.
• Do not place anything near the ventilation holes or
touch these holes as it may cause internal heat build-
up.
!º
9
7
/
inches)
8
7
(EN)
Advertisement
Table of Contents
