Table of Contents
Advertisement
Projecting
To turn off the power
20
(EN)
8
Press the SHIFT +/– key on the Remote Commander or the control
panel to adjust the vertical position of the picture.
"PICTURE SHIFT" appears on the screen during adjustment.
To
Adjust the volume
Cut off the sound
Cut off the picture
Notes
• Do not look into the lens when the projector lamp is on.
• When you adjust the focus, zoom, and shift with the Remote
Commander, be sure to set the SWITCHER/INDEX/LENS selector to the
LENS position.
1
Press the POWER OFF key on the Remote Commander or the control
panel.
The POWER indicator flashes in green and the cooling fan keeps
running for about two minutes to reduce the internal heat. The POWER
indicator flashes quickly for the first minute. During this time, you will
not be able to turn the power back on. After about one minute, you can
turn on the power with the POWER ON key.
2
Wait until the fan stops running and the STANDBY indicator lights in
red; then press the MAIN POWER switch to turn off the main power
(o OFF).
Notes
• Do not press the MAIN POWER switch while the fan is still
running; the fan will stop while the lamp is still hot, leading to
breakdown.
• To make the lamp life last longer, do not turn off the power at least
for about 10 minutes after turning on the power.
Press
the VOLUME +/– keys.
the AUDIO MUTING key (also cut off
the signal output from the AUDIO OUT
jacks.) To restore the sound, press the
AUDIO MUTING key again or press
the VOLUME + key.
the PICTURE MUTING key (PIC
MUTING key on the Remote
Commander). To restore the picture,
press the PICTURE MUTING key
again.
Advertisement
Table of Contents
