Dukane 9080WUSS User Manual page 72

Communication settings
3. Response code / Error code
("h" shows hexadecimal)
4. ACK reply : 06h
When the projector receives the Set, Increment, Decrement or Execute , command correctly, the projector changes the
setting data for the specified , item by [Type], and it returns the code.
5. NAK reply : 15h
When the projector cannot understand the received command, the projector , returns the error code. In such a case, check
the sending code and send the same command again.
6. Error reply : 1Ch + 0000h
When the projector cannot execute the received command for any reasons, the projector returns the error code. In such a
case, check the sending code and the setting status of the projector
7. Data reply : 1Dh + xxxxh
When the projector receives the GET command correctly, the projector returns the response code and 2 bytes of data.
Note
-For connecting the projector to your devices, please read the manual for each devices, and connect them correctly with
suitable cables.
-Operation cannot be guaranteed when the projector receives an undefined command or data.
-Provide an interval of at least 40ms between the response code and any other code.
-The projector outputs test data when the power supply is switched ON, and when the lamp is lit. Ignore this data.
-Commands are not accepted during warm-up.
-When the data length is greater than indicated by the data length code, the projector ignore the excess data code.
Conversely when the data length is shorter than indicated by the data length code, the projector returns the error
code to the computer.
72