Zenith G4 User Manual page 19

LCD Screen operation - Section G
Safety
To set the tap safety setting:
• Press [MENU] button for main
menu.
• Press [Setting] button.
• Press [Safety] button.
• Press button - YES to allow
A
the safety setting to be changed
on the tap
To Enable or Disable the safety on the tap
• Press button B to select Enable / Disable
Note: When NO is selected, the safety lock
it's current setting. To change the safety settings, first select YES before
making the change.
Hot Isolation: (Not for the IT - Two button tap)
The HydroTap is equipped with a safety mode that allows for additional
safety protection, if needed.
When activated, the HOT Isolation mode will override the settings to ensure
Boiling water is not dispensed.
To Activate the Hot Isolation:
• Press button - to Enable / Disable Hot isolation.
C
• To operate the tap when in Hot Isolation mode (Not for the IT - Two button
tap), press the Safety (3) three times, after a few seconds the tap lights
will flash (3) three times. This confirms de-activation and allows Boiling
water to be dispensed . The Hot Isolation can be immediately set again, by
pressing the safety lock (3) times.
• If the Hot Isolation is not re-enabled, it will be automatically re-enabled
after 30 seconds of inactivity.
*
Note: Hot Isolation - cannot be activated or deactivated from the IT -
Two button tap.
802743NZ - HT G4-BC-IS-IT, User Guide - Aug 2015 - V2.00
cannot be changed from
B
Page 19 of 24
A
B
C
*