Table of Contents
Advertisement
Wake-up Function Settings
►
Press [Enter] to make settings for the following sub-items:
Wake-up System with Fixed Time
Use this item to enable or disable system wake on alarm event.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will wake on the Hour/Minute/Second specified.
Wake-up System with Dynamic Time
Use this item to enable or disable system wake on alarm event.
System will wake on the current time + Increase minutes.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will wake on the current time + increased
minute(s).
PS2 KB/MS Wake-up
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable PS2 KB/MS wake-up from S3/S4/S5.
* Note: This function is supported when 'ERP Support' is set as [Disabled].
USB S3/S4 Wake-up
Use this item to enable or disable USB S3/S4 wake-up. This function is only
supported when ERP function is disabled.
* Note: This function is supported when 'ERP Support' is set as [Disabled].
USB S5 Power
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable USB power after power shutdown.
* Note: This function is supported when 'ERP Support' is set as [Disabled].
Ring Wake-up
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable ring wake-up.
* Note: This function is supported when 'ERP Support' is set as [Disabled].
Super I/O Configuration
►
Press [Enter] to make settings for the following sub-items:
ERP Support
The optional settings: [Disabled]; [Auto].
This item should be set as [Disabled] if you wish to have all active wake-up
functions.
Super IO Configuration
► Serial Port 1 Configuration
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM).
The optional settings are: [Disabled]; [Enabled].
Change Settings
Use this item to select an optimal setting for super IO device. Changing setting
may conflict with system resources.
Transmission Mode Select
The optional settings are: [RS422]; [RS232]; [RS485].
Mode Speed Select
The optional settings are: [RS232/RS422/RS485=250kbps]; [RS232=1Mbps,
24
Advertisement
Table of Contents
