JETWAY MM91 Series User Manual page 27

The optional settings are: [C0/C1]; [C2]; [C3]; [C6]; [C7]; [C7S]; [C8]; [C9]; [C10];
[CPU Default]; [Auto].
SATA Configuration
►
Press [Enter] to make settings for the following sub-items:
SATA Controller(s)
The optional settings are: [Enabled]; [Disabled].
When set as [Enabled], the following items shall appear:
SATA Mode Selection
Use this item to determine how SATA controller(s) operate.
The default setting is: [AHCI].
SATA1/ SATA2/SATA3
Port
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable each SATA port.
Hot Plug
The optional settings: [Disabled]; [Enabled].
M.2
M.2
Use this item to enable or disable M.2 SATA port.
The optional settings: [Disabled]; [Enabled].
PCH-FW Configuration
►
Press [Enter] to view ME information and make settings in the following sub-items:
Firmware Update Configuration
►
Press [Enter] to make settings for 'ME FW Image RE-Flash'.
ME FW Image Re-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
* In the case that user needs to update ME firmware, user should set 'ME FW
Image Re-Flash' as [Enabled], save the settings and exit. The system will turn off
and reboot after 4 seconds. If the user goes to BIOS screen again will find this
item is set again as [Disabled], but user can still re-flash to update firmware next
time.
Trusted Computing
►
Press [Enter] to enable or disable 'Security Device Support'.
Configuration
Security Device Support
Use this item to enable or disable BIOS support for security device.
The optional settings: [Disabled]; [Enabled].
ACPI Settings
►
Press [Enter] to make settings for the following sub-items:
ACPI Settings
ACPI Sleep State
Use this item to select the highest ACPI sleep state the system will enter when the
suspend button is pressed.
The optional settings are: [Suspend Disabled]; [S3 (Suspend to RAM)].
23