dbx DriveRack Studio User Manual page 17

DriveRack
• You will now rotate the <DATA> wheel to match the same setting as your amplifier
of choice. Note that based on your amp selection, the DriveRack™ PA will initially
display the recommended setting of that particular amp for obtaining maximum
headroom. This is done to match unity gain from the DriveRack™ PA and your
amplifier. Note that if Sub Speakers are included in the speaker selection, you will
be asked if the sub woofer is bridged or mono. For more information regarding
Amplifier gain settings, please refer to the System Setup and Gain Structure information
located in the appendix section.
• Once you have completed your amp level settings, you will press the <NEXT PG>
button, where you will be asked to select a bridged or normal setting fro your low
amp (if used). The display will appear as follows:
• Once have made a bridged or mono selection, press the <NEXT PG> where the
unit will prompt <DATA> wheel to load your new settings. If you do not wish to
load the settings either press the <PROGRAM> button or use the <PREV PG> but-
ton to re-edit your settings, By using your selections, the DriveRack™ will automati-
cally generate a new program and speaker selection which are used to choose the
correct crossover type, parameters, speaker compensation EQ and delay are also
adjusted by the speaker selection. Amplifier parameters are used to set the limiters
to stop amplifier clipping and balance out the crossover levels. You may find that
you want to re-adjust the crossover levels based on your taste and type of music.
Auto EQ WIZARD
• Once you have custom-tailored your system setup, you can now proceed to tune
your listening environment .The Auto EQ Wizard automatically adjusts the response
of the system by producing pink noise and adjusting the Graphic EQ until the RTA
matches a selected response. From the DriveRack Studio Wizard menu, rotate the
<DATA> wheel until the display appears as follows:
• Either press the <NEXT PG> button or rotate the <DATA> wheel and the display will read:
®
®
Studio
High Amp Level
Adjust level
same as your amp
>25
Low Amp Bridging
Select
same as your amp
>Normal
DriveRack PA WIZARD
System Setup
Auto EQ WIZARD
AFS WIZARD
Getting Started
DriveRack Studio User Manual
Section 1
7