Sony Betacam SX DNV-5 Maintenance Manual page 135

7. S slider assembly removal
Slide the S slider assembly backward and extract
it from the S rail.
Installation
8. S slider assembly installation
Pass the pins of the S slider assembly through the
groove of the S rail in the order of pins 1 to 5 and
insert it until the S slider assembly is put in the
holder of the S rail.
m
. Insert the S slider assembly correctly in the
order of pins. (Tape guide S2 should be put in
front of tape guide S1.)
. Do not apply excessive force to the S slider
assembly and S rail during insertion.
After installation, confirm that the heads of each
pin are not out of the groove of the rail.
9. S rail installation
(1) Insert the hook at the back of the S rail under
the S catcher and lower the front part in the
direction indicated by arrow A.
(2) Pass the hole of the S link assembly through
the pin of the gear ST arm and install it with a
stop washer.
n
Do not apply excessive force to the gear ST
arm when installing the stop washer.
(3) Install the S rail with five screws.
[Tightening torque:
9 x 10 _2 N.m (0.9 kgf.cm)]
10. Cassette stopper installation
(Refer to section 3-3-17.)
11. Threading arm assembly installation
(Refer to section 3-3-20.)
DNV-5
DNW-7/90/90WS
http://getMANUAL.com
S rail
S rail
S slider assembly
Stop washer
Screw
(P1.4 x 3.5)
Hole of the
S link assembly
S rail
A
Pin of the gear
ST arm
3-3-18. S Slider Assembly Replacement
S slider assembly
Tape guide S2 Tape guide S1
(roller of resin)
Pin 5
Pin 4
Pin 3
Pin 2
Pin 1
Holder
Screws
(P1.4 x 3.5)
S catcher
S slider
assembly
Hook of the
S rail
3-85