Replacement Of Dc Fan - Sony HDC-P1 Maintenance Manual

2-3. Replacement of DC Fan

1. Remove the side panel (L) assembly and the
side panel (R) assembly.
(Refer to Section 1-5.)
2. Remove the rear panel assembly.
(Refer to Section 2-6.)
3. Disconnect the harness from the connector
(CN3) on the SW-1485 board and release the
harness from the harness clamp.
4. Remove the two screws to detach the DC fan,
DC fan cushion, and fan bracket.
5. Remove the DC fan from the fan bracket and
detach the fan cushion.
6. Install the new DC fan by reversing the steps
of removal.
m
. When installing the DC fan, pay attention
to the fan label orientation and the harness
lead-out direction.
. When installing the DC fan, pass the har-
ness through the notch on the SW-1485
board so that the harness is not caught.
2-6 (E)
PSW M2 x 5 PSW M2 x 5
Notch Notch
CN3 CN3
SW-1485 board SW-1485 board
Harness clamp Harness clamp
Fan bracket Fan bracket
Fan cushion Fan cushion
Fan label Fan label
DC fan DC fan
(40 x 10) (40 x 10)
Rear panel Rear panel
assembly assembly
Notch Notch
HDC-P1