Replacing Ccd Unit Boards; Dr-632P Board; Nr-80P Board - Sony HDC-P1 Maintenance Manual

2-2. Replacing CCD Unit Boards

2-2-1. DR-632P Board

1. Remove the side panel (L) assembly and the
side panel (R) assembly.
(Refer to Section 1-5.)
2. Remove the CCD unit. (Refer to Section 2-1.)
3. Remove the TG-265PT board.
(Refer to Section 2-2-4.)
4. Disconnect the fl exible card wires from the
connectors (CN1, CN2, CN3, CN4) on the
DR-632P board.
n
Be careful not to bend the fl exible card wire.
This shortens the wire life.
5. Remove the three screws to remove the
DR-632P board.
6. Install a new DR-632P board by reversing the
steps above.

2-2-2. NR-80P Board

1. Remove the side panel (L) assembly and the
side panel (R) assembly.
(Refer to Section 1-5.)
2. Remove the CCD unit. (Refer to Section 2-1.)
3. Disconnect the fl exible card wires from the
connectors (CN1, CN2) on the NR-80P board.
4. Remove the three screws to remove the
NR-80P board.
5. Install a new NR-80P board by reversing the
steps above.
HDC-P1
PSW2 x 5 PSW2 x 5
CN3 CN3
DR-632P board DR-632P board
CN4 CN4
CN1 CN1
CN2 CN2
CN2 CN2 PSW 2 x 5 PSW 2 x 5
CN1 CN1
NR-80P board NR-80P board
2-3 (E)