Epson Megaplex MG-50 User Manual page 67

Light status during normal operation
Light status
Power button and
power light are on.
Lights indicating a problem
Light state
All lights are off.
The temperature
light flashes
orange and the
power button
and light are
flashing.
The lamp light
state will vary
according to the
projector's
status.
The temperature
light is red.
The lamp light
flashes orange
and the
button and light
are flashing.
The temperature
light state will
vary according to
the projector's
status.
Cause and solution
Projection is in progress.
Cause and solution
The projector is not receiving power. Make sure the power
cord is connected securely at both ends. Also check to see if
the Illumination setting is to Off. See page 50.
The projector is too hot. High-speed cooling is in progress. If
the temperature rises further, projection will stop
automatically. Make sure there is plenty of space around the
projector for ventilation. Clean or replace the air filter if
necessary (see page 59).
If you are using the projector at an altitude above 4921 feet
(1500 meters), turn on High Altitude Mode so the fan can
cool the projector properly (see page 50).
The projector is too hot, which turns off the lamp
automatically. Let the projector cool for five minutes, then turn
it back on. Make sure there is plenty of space around the
projector for ventilation. Also, clean or replace the filter if
necessary (see page 59).
If you are using the projector at an altitude above 4921 feet
(1500 meters), turn on High Altitude Mode so the fan can
cool the projector properly (see page 50).
The lamp needs to be replaced (see page 61). Make sure you
have a spare lamp handy. If you just replaced the lamp, you
power may need to reset the lamp usage timer (see page 63).
What To Do When the Lights Come On or Flash
67