Installing Batteries In The Remote Control; Turning The Projector On And Off; Turning On The Projector - Epson Megaplex MG-50 User Manual

Installing Batteries in the Remote Control

The remote control uses two AAA batteries.
Warning: Keep batteries away from children. If a battery is swallowed, contact your doctor
immediately.
1. Release the tab and lift open the cover.
2. Insert two new AAA batteries as shown.
3. Insert the tab on the cover and press it down until it clicks
into place.
Aim the remote control at the screen, or at the front or back of
the projector. Make sure you are within 20 feet (6 m) of the
projector.
If you suspect the batteries are weak, press the
volume buttons do not glow, replace the batteries.

Turning the Projector On and Off

Turning On the Projector

1. Slide open the lens cover.
2. Turn on any connected equipment you plan to use.
3. Press the Ppower button on the remote control or on
the projector.
Note: To prevent children from turning on the projector, you
can use the Child Lock feature. See page 47 for details.
If you'll be using the projector at an altitude above 4921 feet (1500 meters), turn on High Altitude
Mode so the fan can properly cool the projector at the high altitude air pressure. See page 50 for
details.
The projector takes about 30 seconds to warm up and display an image. If you don't see a picture,
you may need to change the image source as described on page 37.
illumination button. If the playback and
Installing Batteries in the Remote Control
17