Table of Contents
Advertisement
Figure 5 - 10 .
Power Supply and AC Line Connector
5 . 5 . 2
REPLACEMENT
1 .
Reconnect the AC line connector and replace the power supply by
gent ly
lowering
printer/plotter AC cable is posit ioned under the power supply sup
port bracket , and that this bracket interlocks with the bracket on
the expans ion board. See Figure 5 - 1 1 .
2 .
Secure the power supply to the support bracket with the two screws .
See Figure 5 - 9 .
3 .
Reconnect the two AC connectors and the two DC connectors to the
power supp ly . See Figure 5 - 9 .
4 .
Posit ion the cable harness clamp assembly over its mounting holes
and secure it with the two screws . See Figure 5 - 6 .
5 .
Reconnect the three harnessed connectors
control board . Be sure a l l the connectors are seated properly .
it
back
into
position .
Removal anJ Rcp l 3cemcnt Procedures
Be
sure
that
the
to
the printer/plotter
5 - 1 3
Advertisement
Table of Contents
