Table of Contents
Advertisement
Print
@)
Figure 5 - 1 8 .
Printer/Plotter and Processor Unit (Bottom View)
5 .
Route the print head cable and motors cable through the r ight rear
of the processor unit . See Figure 5 - 1 8 .
6 .
Replace the print head cab le and motors cab l e on the cable harness
retaining bar and ins t a l l the top port ion of the bar with the p lastic
s crews . See Figure 5 - 15 .
7 .
Holding the printer/plotter by the front , l ift the assembly and push
forward and then down unt i l the hooks latch onto the studs on the
processor unit .
assemblies . See Figure 5 - 1 9 .
(J100)
Head
Check that the cables are not crimped between the
Removal and Replacement Procedures 5 - 2 7
Advertisement
Table of Contents
