GBC Docuseal 2700 Service Manual page 5

ELECTRICAL SAFEGUARDS
•
Do not alter the attachment plug. This plug is configured for the appropriate electrical
supply.
•
This unit is intended for indoor use only.
•
The receptacle must be located near the equipment and be easily accessible. Do not use
an extension cord.
SET UP
•
Shipping damage should be brought to the immediate attention of the delivering carrier.
•
Place the laminator on a stable flat surface capable of supporting 125 lbs. The surface
should be at least 30" high to assure comfortable positioning during operation. All four
rubber feet should be on the supporting surface.
•
Connect power cord to an appropriate power source. A void connecting other equipment
to the same branch circuit to which the laminator is connected as this may cause nuisance
tripping of the circuit breaker or blown fuses.
•
The laminator should be positioned to allow exiting film to drop freely to the floor.
Accumulation of laminate as it exits the laminator may cause film to wrap around the
rollers, causing a jammed condition.
•
A void placing laminator near sources of heat or cold. A void locating the laminator in the
direct path of forced, heated or cooled air.
3.0 INSTALLATION