Installation; General Safeguards; Electrical Safeguards - GBC Docuseal 2700 Service Manual

WARNING:
For your protection, do not connect the laminator to electrical power or attempt to
operate until you read these instructions completely. Keep operating instructions in a convenient
location for future reference. To guard against injury, the following basic safety precautions must
be observed in the set up and use of the laminator.

GENERAL SAFEGUARDS

•
Use this laminator only for its intended purposes as according to the specifications
outlined in the operating instructions.
•
Keep hands, long hair, loose clothing and articles such as necklaces or ties away from the
front of the pull rollers to avoid entanglement and entrapment.
•
A void contact with the heat shoes during operation or shortly after the laminator has been
turned off. The heat shoes can reach temperatures in excess of 300
•
Keep hands and fingers away from the path of the sharp film cutter blade located at the
film exit.
•
Do not place the laminator on an unstable cart, stand or table. An unstable surface may
cause the laminator to fall resulting in serious bodily injury. Avoid quick stops, excessive
force and uneven floor surfaces when moving the laminator on a cart or stand.
•
Do not defeat or remove electrical and mechanical safety equipment such as interlocks,
shields and guards.
•
Do not insert objects unsuitable for lamination.
•
Do not expose laminator to liquids.

ELECTRICAL SAFEGUARDS

•
This laminator must be connected to a supply voltage corresponding to the electrical
rating as indicated on the serial plate located on the rear of the machine.
•
Unplug the laminator before moving it, or when it is not in use for an extended period of
time.
•
Do not operate the laminator with a damaged power supply cord or plug.
•
Do not overload electrical outlets as this can result in fire or shock.

3.0 INSTALLATION

F.
°