Servicing Schedule - Jonsered FR 2216MA Workshop Manual

The following is a list of maintenance procedures that
must be performed on the ride-on mower. Most points
not described in this workshop manual can be found in
the operator's manual.
* = General maintenance done by the operator.
O = The instructions are given in this workshop manual.
Maintenance
Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
Clean the product
Clean the inner surface of the cutting deck, around the blades
Clean around the muffler
Make sure that the cold air intake of the engine is not blocked
Make sure that the safety devices are not defective
Examine and do a test of the brakes
Do a check of the engine oil level
Do a check of the oil level in the transmission
Do a check of the steering cables
Examine the blades in the cutting deck
Clean the cutting deck, below the belt covers and below the cutting
deck
Make sure that the tire pressure is correct
Do a check of the parking brake
Change the engine oil
Change the oil filter
Clean the air filter
Change the air filter
Change the fuel filter
Do a check of the parallelism of the cutting deck
Lubricate the belt adjuster.
Examine and adjust the steering cables
Examine the muffler and heat deflector
Examine the cutting deck for damages
Change the spark plug
Adjust the parking brake.
Do a check of and adjust the throttle wire
Clean the cooling fins on the engine and the transmission
Clean the engine and the transmission
Do a check of the belts

10 - Servicing schedule

5 Servicing schedule
X = The instructions are not given in this workshop
manual.
Note: If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
Daily maintenance be- Maintenance interval in
fore operation hours
25
*
*
X
X
X
X
X
*
O
O
O
X
O
X
O
X
O
O
50 100 200
X
O
O
O O
X X
X
X
O
X
O
O
O
O
O
O
O
O
O
659 - 001 - 11.04.2018