Set Up And Operation - Shop-Vac SC14 Series User Manual

3. Remove any webbing that attaches the tank handles to each other. Take the side
tank handle with the letter L and position it on the outside of the tank where the
support assemblies are installed. The U-shaped cutout on the bottom end of the
handle must face the rear of the tank. Secure the side tank handle to the tank
with the screws in the support assemblies.
4. Repeat steps 1 to 3 using right side of tank and the remaining side tank handle
marked with the letter R.
5. Position metal carriage handle outside of tank and under the tank handles. Be
sure to spread ends of carriage handle when assembling to prevent damage
to tank. Line up holes in ends of carriage handle with holes in bottom of tank
handles. Make sure carriage handle is in the U-shaped cut on the tank handles
(located towards rear of unit). Secure with 1½" screws provided.
HOSE HOLDER INSTALLATION
(Not standard with all models)
If not already installed, assemble as follows:
1. With rear of unit facing you, take hose holder and position it with tabs facing rear of
unit.
2. Place "J" shaped tabs into the slots on cord wraps. Press down until tabs snap into
place.
3. Press down on center of hose holder until tab latches on bottom of tank cover.
1. Refer to the filter installation and maintenance section to make sure the correct filters are installed for
your cleaning operation.
2. Replace tank cover and apply pressure with thumb to each latch until it snaps tightly into place. Make
sure each latch is clamped securely.
3. Insert machine hose end with locking-nut into inlet located on the front of the tank.
Turn locking nut to tighten. Do not over-tighten.
4. Attach the extension wands to the accessory end of the hose. Twist the wands slightly at each
connection to secure them into place. NOTE: If an elbow grip (not standard on all models) has been
included with your vacuum, it can be placed between the accessory end of hose and the extension
wands for a more comfortable hand grip.
5. Attach one of the cleaning accessories (depending on your cleaning requirements) onto the extension
wands. Twist the accessory slightly to tighten the connection. NOTE: Many more useful tools are
available at your local dealer or the Shop-Vac
6. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
ASSEMBLY (CONT'D.)

SET UP AND OPERATION

® website.
PAGE 7