Assembly; Set Up And Operation - Shop-Vac 4045AH User Manual

3. Attach caster system following the instructions and illustrations in this manual.
4. Attach side tank handles following the instructions and illustrations in this manual.
5. Before replacing tank cover, please refer to Dry Pick Up or Wet Pick Up Operation in
this manual to ensure you have the proper filters installed for your cleaning operation.
6. Replace tank cover, and apply pressure with thumb to each latch until it snaps
tightly in place. Make sure all lid latches are clamped securely.
7. Insert machine hose end into inlet of tank. Twist slightly to tighten the
connection.
8. Attach the extension wands to the accessory end of the hose. Twist slightly to
tighten the connection.
9. Attach one of the cleaning accessories (depending on your cleaning requirements) to the extension
wands. Twist slightly to tighten the connection.
10. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O =OFF
1. With cord disconnected from receptacle and tank cover removed, turn tank
upside down so that the bottom is facing up.
2. Insert casters into bottom of dolly by placing stem of caster into holes provided.
Apply pressure and twisting motion until casters snap into place. Return tank to
upright position.
SIDE TANK HANDLE ASSEMBLY
Attach side handles to tank with screws provided.
VACUUM SET UP AND OPERATION
DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct filters are installed for
normal dry or wet pick up operation based on your cleaning needs.
CASTER SYSTEM ASSEMBLY
–
This equipment incorporates parts such as switches, motors or the
PAGE 5