Set Up And Operation - Shop-Vac 24LSR Series User Manual

4. Slide axle through holes provided in basket.
5. Slide remaining wheel onto axle. Make sure wheels are positioned correctly. hammer
on second cap nut.
6. With front of tank facing you, take basket assembly and place into slots on back of
tank. Secure with screws provided.
7. Take caster foot marked with the letter A and place in slot on left front of tank also
marked with letter A. Secure with screw provided.
8. Take caster foot marked with the letter B and place in slot on right front of
tank also marked with the letter B. Secure with screw provided.
9. If flat washers are included in hardware package place flat washer over
stem of caster before installing casters into feet. NOTE: Flat washers are not
required with all units.
10. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. Return tank to
upright position.
CARRIAGE HANDLE
If your vacuum comes with a carriage handle, assemble as follows:
1. Stand tank in the upright position. Spread ends of carriage handle (to prevent damage to
tank) while placing them under the side tank handles.
2. Align holes in carriage handle with holes in tank. Fasten
tightly with screws, washers and nuts provided. The
rubber side of the washers must be placed against the
inside wall of the tank to prevent leakage or loss of
performance.
DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
PAGE 6
ASSEMBLY (CONT'D)

SET UP AND OPERATION

–
This equipment incorporates parts such as switches, motors or the
Screw
Caster
Foot
Screw
Caster
Foot
Caster
Caster
Foot
Poignée
de transport
Rondelle
Contre-écrou
d'étanchéité
à tête hexagonale
Vis