Operating Ebl, Vrm, And Pi With Cursor - JRC JMA-9123-7XA Instruction Manual

>
JMA-9100 Instruction Manual 4.MEASUREMENT OF RANGE AND BEARING
4.1.6

Operating EBL, VRM, and PI with Cursor

When the cursor mode is set to
display), EBL, VRM, and PI can be operated simply by using the trackball.
4.1.6.1 Operating Electronic Bearing Line (EBL)
Procedures
1) Put the cursor on EBL1 or EBL2, and left-click.
When the cursor is moved to it, EBL1 or EBL2 is shown at the upper right of the cursor.
The EBL becomes operable when left-clicking. カーソルを合わせるとカーソル右上に
EBL1
す。
2) Move the cursor to the bearing to be set.
The EBL will move as the cursor moves.
3) Left-click.
The EBL will be fixed.
4.1.6.2 Operating Variable Range Marker (VRM)
Procedures
1) Put the cursor on VRM1 or VRM2, and left-click.
When the cursor is moved to it,
the cursor. The VRM becomes operable when left-clicking.
2) Move the cursor to the range to be set.
The VRM will move as the cursor moves.
Left-click.
3)
The VRM will be fixed.
AUTO
EBL2
または が表示されます。左クリックすると操作状態になりま
VRM1
4－ 16
>
4.1 USE OF NAVIGATION TOOLS
(located at the upper right of the
or VRM2 is shown at the upper right of