Table of Contents
Advertisement
EVGA Z490 FTW (122-CL-E497)
POST Codes
This section provides the AMI POST Codes
for the EVGA Z490 FTW Motherboard
during system boot up. The POST Codes
are displayed on the Debug LED readout
located directly on the motherboard.
See Page 11 and 12, component 19 of the
Component Legend for physical location.
This Debug LED will switch to display the user's 80Port Configuration settings
after POST (see Page 151). Please note that if you see the Debug LED
constantly switching numbers after entering Windows, the Debug LED is
showing temperature or voltage information, and is NOT reporting errors.
AMI POST Codes
1
Power on. Reset type detection (soft/hard).
2
AP initialization before microcode loading
3
North Bridge initialization before microcode loading
4
South Bridge initialization before microcode loading
5
OEM initialization before microcode loading
6
Microcode loading
7
AP initialization after microcode loading
8
North Bridge initialization after microcode loading
9
South Bridge initialization after microcode loading
0A
OEM initialization after microcode loading
0B
Cache initialization
0C-0D Reserved for future AMI SEC error codes
0E
Microcode not found
Debug LED with CPU
Temperature Monitor
- 155 -
Advertisement
Table of Contents
