Default Settings; Built-In Fonts And Character Tables - Epson Stylus Color 600 User Manual

Specifications

Default Settings

Built-in Fonts and Character Tables

Note:
The font and character table selections you make with your software override the settings you
make using the default setting mode. For best results, use your software to make these settings.
The table below shows the default settings that take effect when the
printer is initialized. To change these settings, follow the instructions
in "Built-in Fonts and Character Tables."
Item
Top-of-form position
Page length
Left and right margins
Line spacing
Character pitch
Vertical tab position
Horizontal tab positions
Font selection
Special printing effects
User-defined character set Hardware/control panel initialization: cleared
Your printer has eight built-in fonts and eleven character tables that
you can select using the printer's default setting mode as described
below. The setting you choose takes effect each time you turn on the
printer. Available fonts and character tables are listed on page A-2.
To change the default font or character table, follow these steps:
1. Make sure the printer is turned off and paper is loaded in the
sheet feeder. (Use paper at least 8.3 inches wide. Otherwise the
print heads will spray ink directly onto the platen.)
2. Hold down the R
The printer loads a sheet of paper and prints a brief summary and
instructions.
3. Follow the instructions on the sheet and press the
button until the control panel lights indicate the language of your
choice.
A-8
Default setting
Current paper position
Single sheets: 22 inches
Cancelled
1/6-inch line spacing
Last font selected using default setting mode
Cleared
Every eight characters
Last font selected using default setting mode
Cancelled (except condensed and economy
printing)
Software initialization: deselected only
cleaning button and turn on the printer.
cleaning
R