Panasonic KX-TGW420 Operating Instructions Manual page 9

Note when setting up
Note for connections
R The AC adaptor must remain connected at all
times. (It is normal for the adaptor to feel warm
during use.)
R The AC adaptor should be connected to a
vertically oriented or floor-mounted AC outlet.
Do not connect the AC adaptor to a horizontally
oriented AC outlet that faces the floor, such as
an AC outlet installed on a ceiling or under a
table, as the weight of the adaptor may cause it
to become disconnected.
Connecting the desk stand
The angle of base unit can be adjusted by
attaching the desk stand. You can choose from 2
position when attaching.
Base unit battery installation (for
power back-up)
By inserting 5 alkaline batteries (not supplied) into
the base unit, you can use the unit temporarily
when a power failure occurs.
R USE alkaline batteries AAA (LR03) size.
R Do NOT use Manganese batteries.
R Confirm correct polarities (
1
Disconnect the telephone line cord(s) (A).
2
Open the battery cover (B).
3
Install the batteries in the battery compartment
(C, D).
4
When finished, close the cover (E), then
reconnect the telephone line cord(s) (F).
For assistance, please visit http://shop.panasonic.com/support
TGW420_(en)_OI_1226_ver06.pdf 9
, ).
Note:
R If "Replace Battery" is displayed, replace
the batteries with new ones as soon as possible
for temporary use, then dispose old ones.
R If there is a connected device (for example, a
modem) between the base unit and the
telephone line jack, the power back-up
Getting Started
B
C
D
E
2019/12/26 13:15:31
A
F
9