Panasonic KX-TGW420 Operating Instructions Manual page 23

2
MbN: "Add/Remove Phones" a MSelectN
3
MbN: "Refresh List" a MSelectN
4
Press MBackN or MHomeN repeatedly to return
to standby mode.
Storing area code
You can program this phone to recognize one
home and up to 6 local area codes.
– If you set the home area code, the display
shows the 7 digits (without "1" and area code)
of the phone number when you receive a call
from your home area code.
– If you set the local area code, you can dial 10
digits (without "1") to make a call outside your
home area code and the display shows the 10
digits (without "1") of the phone number when
you receive a call from one of your local area
codes.
1
MMenuN
2
MbN: "Phone Settings" a MSelectN
3
MbN: "Area Codes" a MSelectN
4
MbN: Select the area code you want to set. a
MSelectN
5
Enter the 3-digit area code. a MSelectN
R To erase the area code, press MClearN.
6
Press MBackN or MHomeN repeatedly to return
to standby mode.
Setting the delay ring
This feature allows you to delay this unit ringer.
You can select "1 Ring" to "9 Rings", or "No
Delay". The default setting is "No Delay".
1
MMenuN
2
MbN: "Phone Settings" a MSelectN
3
MbN: "Delay Ring" a MSelectN
4
MbN: Select the desired setting. a MSelectN
5
Press MBackN or MHomeN repeatedly to return
to standby mode.
Resetting the phone settings
This feature allows you to reset the user-defined
settings, and return to the default settings.
1
MMenuN
2
MbN: "Phone Settings" a MSelectN
3
MbN: "Reset Phone Settings" a MSelectN
For assistance, please visit http://shop.panasonic.com/support
TGW420_(en)_OI_1226_ver06.pdf 23
4
MbN: "Yes" a MSelectN
5
MbN: "Confirm" a MSelectN
6
Press MBackN or MHomeN repeatedly to return
to standby mode.
Note:
R The following contents will be retained even if
you reset the phone settings:
– Date time setting
– Caller list
– Phonebook
– All greetings and all messages
Restoring the default settings
This feature will restore the phone settings to
factory settings.
Note:
R The following contents are also erased by
restoring to the factory default settings.
– Caller list
– Phonebook
– All greetings and all messages
1
MMenuN
2
MbN: "Factory Reset" a MSelectN
3
MbN: "Yes" a MSelectN
4
MbN: "Confirm" a MSelectN
Programming
23
2019/12/26 13:15:32