Error Messages And Troubleshooting - Omron BP7455CAN Instruction Manual

7. Error Messages and Troubleshooting

If any of the below problems occur during measurement, check to
make sure that no other electrical device is within 12 inches (30 cm).
If the problem persists, refer to the table below.
Display/
Problem
appears or the
arm cuff does
not inflate.
Possible Cause
The [START/STOP]
button was pressed
while the arm cuff is not
applied.
Air plug is not
completely plugged into
the monitor.
The arm cuff is not
applied correctly.
Air is leaking from the
arm cuff.
Solution
Press the [START/STOP]
button again to turn the
monitor off. After inserting
the air plug securely and
applying the arm cuff
correctly, press the
[START/STOP] button.
Insert the air plug
securely. Refer to
sub-section 2.6.
Apply the arm cuff
correctly, then take
another measurement.
Refer to sub-section 2.6.
Replace the arm cuff with
a new one. Refer to
section 9.
EN
39