Running The Cleaning Cycle - Epson EPI-4000 User Manual

Running the Cleaning Cycle

To run the cleaning cycle, follow these steps:
1. Make sure the printer is off line. If the ON LINE light is on, press
ON LINE to set the printer off line.
2. Open the printer cover. Then press SelecType to enter SelecType
mode. The SelecType light goes on.
Press CLEANING briefly. Then release the printer cover support
3.
and close the printer cover. The display reads CL, the print head
cleaning message, and the printer runs the cleaning cycle.
4. If print quality problems persist, repeat the previous four steps
to run the cleaning cycle again.
Note: If there is paper in the paper path when you try to run the
cleaning cycle, the printer will not perform the entire cycle (the
print head will not move to the right for brush cleaning).
Maintenance and Transportation
Cleaning the Print Head
5-5