Viessmann VITOCAL 060-A Operating Instructions For The System User page 8

Introductory information
Energy saving tips
■ DHW consumption:
Consider showering instead of running a bath. A
shower generally uses less energy than a full bath.
Low DHW demand (see page 16):
■
Heat up the DHW cylinder less often.
For this, consult your contractor.
■ Time program (see page 15):
Switch off DHW heating, for example at night or if
you are going away for a long time. Set this via the
time program.
■ Immersion heater:
Switch off automatic DHW cylinder reheating by the
immersion heater. Set the "ECO" operating program.
Tips for greater comfort
Higher DHW demand:
■
Heat up the DHW cylinder more often. For this, con-
sult your contractor (see page 15).
■ Use the immersion heater for automatic DHW cylin-
der reheating, e.g. at low ambient or outside temper-
atures, or if the DHW heat pump develops a fault.
Set the "AUTO" operating program.
■ "BOOST" operating program (see page 12):
You can heat up the DHW cylinder immediately,
regardless of the time program. For quick heat-up,
set the "BOOST" operating program.
Preheating:
■
Use the "ECO" operating program to preheat the
DHW cylinder to the maximum set DHW temperature
of the heat pump.
!
Please note
Operating the system with incorrect settings
will result in appliance damage.
Do not set the set DHW temperature of the
heat pump higher than 45 °C for preheating.
8
Utilisation of power generated on site (in conjunc-
tion with a photovoltaic system)
Use the power generated by your photovoltaic sys-
■
tem for DHW heating (see page 17).
For additional energy saving functions of the heat
pump control unit, please contact your contractor.