Table of Contents
Advertisement
Unpacking
This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage. If items are damaged,
please call us immediately at (570) 546-9663.
IMPORTANT: Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.
SUFFOCATION HAZARD!
Keep children and pets away
from plastic bags or packing
materials shipped with this
machine. Discard immediately.
Needed for Setup
The following items are needed, but not included,
for the setup/assembly of this machine.
Description
•
Hex Wrench 5mm ....................................... 1
•
Hex Wrench 2.5mm .................................... 1
•
Open-End Wrench 15mm ........................... 1
•
T-Bolts, Studs & Hex Nuts
•
Open End Wrench or Socket
•
C-Clamp Set (optional) ............................... 1
Model T25937 (Mfd. Since 3/16)
SECTION 2: SETUP
Qty
⁄
" .................... 2
1
2
⁄
" ................ 1
3
4
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 4):
A. Rotary Table & Vise ................................... 1
B. Dividing Plates ............................................ 3
C. Vise Jaws ................................................... 4
D. Collet Wrench ............................................. 1
E. Step Clamps ........................................2 Pair
F.
Step Blocks .........................................2 Pair
G. Crank Handle w/Pin .................................... 1
H. T-Slot Bolt Assemblies
—Threaded Studs M8-1.25 x 80 ................ 4
—T-Nuts 8mm ............................................ 4
—Flange Nuts 8mm ................................... 4
I.
Tailstock ...................................................... 1
J.
Phillips Head Screws M5-.8 x 12................ 3
K. Sector Arm ................................................. 1
L. Sector Arm Spring Clip ............................... 1
A
D
H
J
K
Figure 4. Box inventory.
Qty
B
C
E
G
F
I
L
-7-
Advertisement
Table of Contents
