Recorded Data Display; Recorder Options - Fluke ScopeMeter 190 Series III User Manual

190 Series III
Users Manual
When the test tool is in automatic mode, automatic vertical scaling is used to fit the TrendPlot
graph on the screen.
Scope TrendPlot is not possible on cursor related measurements. As an alternative you
may use the PC software FlukeView™ ScopeMeter™.

Recorded Data Display

When in normal view (NORMAL), only the twelve most recently recorded divisions are displayed
on screen. All previous recordings are stored in memory.
VIEW ALL shows all data in memory:
1. Press 3 to show an overview of the full waveform.
2. Press 3 repeatedly to toggle between normal view (NORMAL) and overview (VIEW
ALL).
When the recorder memory is full, an automatic compression algorithm is used to compress all
samples into half of the memory without loss of transients. The other half of the recorder memory
is free again to continue recording.

Recorder Options

At the lower right of the display, the status line indicates a time. You can choose this time to
represent either the start time of the recording (Time of Day) or the time elapsed since the start of
the recording (From Start).
To change the time reference:
1. Press 2 to open the RECORDER OPTIONS menu.
2. Use the cursor and E to select Time of Day or From Start.
32
sales@GlobalTestSupply.com
Figure 17. TrendPlot Reading
Note
Fluke-Direct
.com
1.888.610.7664