Automatic Scope Measurements - Fluke ScopeMeter 190 Series III User Manual

190 Series III
Users Manual
L K
N V at the bottom of the keypad to change the view of the waveform
Use
manually.

Automatic Scope Measurements

The test tool offers a wide range of automatic scope measurements. In addition to the waveforms
you can show four numeric readings: READING 1 - 4. These readings are selectable
independently, and the measurements can be done on the input A, input B, input C or input D
waveform.
To choose a Peak-Peak measurement for Input A, do the following:
P
1. Press
2. Open the READING menu with 2.
3. Select the reading number with 1, for example READING 1.
4. Use the cursor and E to select on A. Observe that the highlight jumps to the present
measurement.
5. Use the cursor and E to select the Hz measurement.
Observe that the top left of the screen shows the Hz measurement. See
To choose also a frequency measurement for Input B as second reading:
P
1. Press
2. Open the READING.. menu with 2.
3. Select the reading number with 1, for example READING 2.
4. Use the cursor and E to select on B. The highlight jumps to the measurements field.
5. Use the cursor and E to open the PEAK menu.
14
sales@GlobalTestSupply.com
Figure 5. The Screen After an Auto Set
to show the SCOPE key labels.
to show the SCOPE key labels.
Fluke-Direct
Figure 6.
.com
1.888.610.7664