Cursor Measurements; Horizontal Cursors On A Waveform - Fluke ScopeMeter 190 Series III User Manual

Cursor Measurements

Cursors allow you to make precise digital measurements on waveforms. This can be done on live
waveforms, recorded waveforms, and on saved waveforms.

Horizontal Cursors on a Waveform

To use the cursors for a voltage measurement:
1. From Scope mode, press
2. Press 1 to highlight the horizontal cursor icon.
3. Press 2 to highlight the upper cursor icon.
h i
4. Use
5. Press 2 to highlight the lower cursor.
h i
6. Use
Even when the key labels are not displayed at the bottom of the screen, you can use the
cursor. This allows full control of both cursors while having full screen view.
The screen shows the voltage difference between the two cursors and the voltage at the cursors.
See Figure
of a waveform.
sales@GlobalTestSupply.com
G
to move the upper cursor position on the screen.
to move the lower cursor position on the screen.
22. Use horizontal cursors to measure the amplitude, high or low value, or overshoot
Figure 22. Voltage Measurement with Cursors
Fluke-Direct
to show the cursor key labels.
Note
®
ScopeMeter Test Tool
Replay, Zoom and Cursors
.com
1.888.610.7664
39