Cleaning The Paper Sensors; Cleaning The Adf Sensors - Visioneer PATRIOT PD45 User Manual

V P PD45/PH70
®
ISIONEER ATRIOT
2. The following illustration shows the location of the glass in the scanner.
Use a soft cloth to wipe clean the glass. You can use a roller cleaning paper to clean the glass plates if there is
any sticky residue on the surface.

Cleaning the Paper Sensors

The scanner has several sensors to detect the status of the paper when it is in the scanner. You should clean these
sensors as part of your standard weekly maintenance of the scanner.
Note: Do not clean the sensors with the roller cleaning paper.
Preparation
Turn off the scanner prior to cleaning the sensors.

Cleaning the ADF Sensors

1. Pull on the scanner cover release and lift the lid to open the scanner.
2. The following illustration shows the location of the sensors in the scanner.
3. Using a clean, dry cotton swab, brush away any dust on the double feed detection sensors.
When you are done replacing the rollers, close the scanner carefully pressing down on both sides of the cover
until it locks in place. Do not slam down the cover.
42
M
AINTENANCE
S U G
CANNER SER UIDE