Filling The Fuel Tank; Performing Daily Maintenance; Checking The Interlock System - Toro Reelmaster 3100-D Operator's Manual

Filling the Fuel Tank

Fuel tank capacity: approximately 28 L (7.5 US
gallons)
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Clean the area around the fuel-tank cap
46).
Figure 46
1. Fuel-tank cap
3. Remove the fuel-tank cap.
4. Fill the tank to the bottom of the filler neck.
Note:
Do not overfill the fuel tank.
5. Install the cap.
6. Wipe up any spilled fuel.
Performing Daily
Maintenance
Service Interval: Before each use or daily
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
(page 40).
Checking the Interlock
System
Service Interval: Before each use or daily
If safety interlock switches are disconnected
or damaged, the machine could operate
unexpectedly, causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
(Figure
Important:
interlock switch checks, contact your authorized
Toro distributor.
Preparing the Machine
1.
2.
Checking the Traction Pedal
Start-Interlock
g191214
1.
2.
3.
4.
5.
Checking the Cutting Unit Drive
Switch Start-Interlock
1.
2.
3.
4.
Maintenance
5.
Checking the Parking Brake and
Seat Run-Interlock
1.
2.
3.
32
CAUTION
switches daily and replace any damaged
switches before operating the machine.
If your machine fails any of the
Drive the machine slowly to an open area.
Lower the cutting units, shut off the engine, and
engage the parking brake.
Sit in the operator's seat.
Engage the parking brake.
Press the cutting unit drive switch to the
D position.
ISENGAGE
Press the traction pedal.
Rotate the key to the S
Note:
The starter should not crank the engine
with the traction pedal pressed.
Sit in the operator's seat.
Engage the parking brake.
Press the cutting unit drive switch to the E
position.
Keep you foot off the traction pedal.
Rotate the key to the S
Note:
The starter should not crank the engine
with the cutting unit drive switch to the E
position.
Sit in the operator's seat.
Engage the parking brake.
Press the cutting unit drive switch to the
D position.
ISENGAGE
position.
TART
NGAGE
position.
TART
NGAGE